Transfer Instructions for Unisub Plastics:

  * Prepare artwork and size transfer according to the size and shape of the product.
  * Image must be produced in reverse or “mirror image”
  * Place a sheet of plain white paper on the press.
  * Remove the protective plastic covering from the product.
  * Using heat resistant tape, secure the image with the printed side of transfer facing the product
  * Lay the imprintable face up on the heat press so that you are pressing onto the transfer.
  * Cover imprintable with a sheet of plain white paper
  * Press at 400 degrees F for 60-70 seconds using Medium pressure
  * When pressing is finished carefully remove the transfer paper and allow to cool on a clean surface
 

Note: If you are using an item that can be printed on both sides allow the plastic to cool to room temperature before pressing the 2nd side.  Refer to the Unisub pressing guide for additional instructions.CLICK HERE

Note: These instructions are guide lines only and are based on the inks, paper, and products we supply. Your inks, papers, etc. may require adjustments in your time/temp settings.

Whether you’re just starting out or already a pro Image Creations is here to support you with
the latest in image transfer technology! 

Image Creations Inc. is not responsible for typographical or photographical errors. Prices and specifications are subject to change without notice.  All pricing is reflected in Canadian Funds.