|
Transfer Instructions for Unisub MDF:
* Prepare artwork and size transfer according to the size and shape of the product.
* Image must be produced in reverse or “mirror image”
* Place a sheet of plain white paper on the press.
* Remove the protective plastic covering from the product.
* Using heat resistant tape, secure the image with the printed side of transfer facing the product
* Lay the imprintable face up on the heat press so that you are pressing onto the transfer.
* Cover imprintable with a sheet of plain white paper.
* Press at 400 degrees F for 80-90 seconds using Medium pressure
* When pressing is finished carefully remove the transfer paper and allow to cool on a clean surface
* If you are using an item that can be printed on both sides, allow the imprintable to cool to room temperature
before pressing the 2nd side. CLICK HERE to refer to the Unisub guide for additional instructions.
Note: These instructions are guide lines only and are based on the inks, paper, and products we supply. Your inks, papers, etc. may require adjustments in your time/temp settings.
|
