|
Transfer Instructions for China Plate:
* Preheat plate puck for 10 min. at 400 degrees
* Lay transfer into plate, securing with heat tape.
* Remove puck from press using pliers CAUTION: Plate puck is extremely hot.
* Place plate on press face up.
* Place thermo rubber matt on top of plate/transfer.
* Carefully place puck onto rubber matt.
* Using firm pressure close heat press and press for 9.5 to 10.5 min
* Carefully remove plate puck and rubber matt, try to limit the amount of movement. Excessive side to side movement
can blur the image.
* Carefully remove the transfer.
Note: These instructions are guide lines only and are based on the inks, paper, and products we supply. Your inks, papers, etc. may require adjustments in your time/temp settings.
|
