Mouse Pads
Add personality and charm to any workstation with your favorite photo or image
Deluxe Mouse Pad w/cream colored backing
Item SMPADW * Deluxe Mouse Pad with white polyester imprinting surface and a cream colored backing Size: 7.75” x 9.25” x .25” x 1″ Radius
Qty 140/case – Broken cases billed as each.
$1.95 ea less than case
$1.80 ea per case
$1.70 ea per 4+ cases
Deluxe Mouse Pad w/black colored backing
Item SMPADK * Deluxe Mouse Pad with white polyester imprinting surface and a cream colored backing Size: 7.75” x 9.25” x 0.22” (5mm) x 1″ Radius
Qty 150/case – Broken cases billed as each.
$1.95 ea less than case
$1.80 ea per case
$1.70 ea per 4+ cases
Hardboard Mouse Pad
Item UNI1010 * Message Board / Mouse Pad THB – Size 7.5” x 9””
Qty 20/case – Broken cases billed as each.
$6.08 ea less than case
$5.13 ea per case
$4.75 ea per 4+ cases
* Prepare artwork and size transfer according to the size and shape of the product.
* Image must be produced in reverse or “mirror image”
* Place a sheet of plain white paper on the press.
* If the product has a protective plastic covering remove it.
* Using heat resistant tape, secure the image with the printed side of transfer facing the product
* Lay the imprintable face up on the heat press so that you are pressing onto the transfer.
* Cover imprintable with parchment or paper
* Press at 385 degrees F for 95-105 seconds using Medium pressure
* When pressing is finished carefully remove the transfer paper and allow to cool on a clean surface
* Prepare artwork and size transfer according to the size and shape of the product.
* Image must be produced in reverse or “mirror image”
* Place a sheet of plain white paper on the press.
* Lay the imprintable face up on the heat press so that you are pressing onto the transfer.
* Cover imprintable with parchment or paper
* Press at 400 degrees F for 50-60 seconds using Light – Medium pressure
* When pressing is finished carefully remove the transfer paper and allow to cool on a clean surface
Note: These instructions are guide lines only and are based on the inks, paper, and products we supply. Your inks, papers, etc. may require adjustments in your time/temp settings.380
These transfer instruction guidelines were created using a Swing-Away GeoKnight Press, size 20″ x 24″/508 x 609.6 mm with pressure of 60 PSI. They represent the best, most general instructions we can provide. Please remember that heat presses may vary. Check with your press manufacturer for any special concerns. This information may change as we make continual improvements and refine our processes. These instructions are guide lines only and are based on the inks, paper, and products we supply. Your inks, papers, etc. may require adjustments in your time/temp settings.