Sublimation Magnets
Magnet - FRP
Item UNI5527 * Magnet (frp) Heart Size 2.5” x 2.25”
Qty 50/case – Broken cases billed as each.$1.97 → $1.47 ea less than case qty$1.66 → $1.24 ea per case
Magnet - Porcelain
Item SHEARTMAG * Porcelain Magnet Size 2.75” x 3 1/4”2.75”
Qty 100/case – Broken cases billed as each.$3.16 → $2.21 ea less than case$3.00 → $2.10 ea per case
* Prepare artwork and size transfer according to the size and shape of the product.
* Image must be produced in reverse or “mirror image”
* Place a sheet of plain white paper on the press.
* Using heat resistant tape, secure the image with the printed side of transfer facing the product
* Lay the imprintable face up on the heat press so that you are pressing onto the transfer.
* Cover imprintable with parchment or paper
* Press at 385 degrees F for 45-55 seconds using Medium pressure
* When pressing is finished carefully remove the transfer paper and allow to cool on a clean surface
* Prepare artwork and size transfer according to the size and shape of the product.
* Image must be produced in reverse or “mirror image”
* Place a sheet of plain white paper on the press.
* If the product has a protective plastic covering remove it.
* Using heat resistant tape, secure the image with the printed side of transfer facing the product
* Lay the imprintable face up on the heat press so that you are pressing onto the transfer.
* Cover imprintable with parchment or paper
* Press at 385 degrees F for 60-65 seconds using Medium pressure
* When pressing is finished carefully remove the transfer paper and allow to cool on a clean surface
* Prepare artwork and size transfer according to the size and shape of the product.
* Image must be produced in reverse or “mirror image” to insure correct application
* Place a neomex felt pad on the bottom platform of the press
* Lay the imprint transfer face up on the neomex pad
* The product is placed coated side face down. (the artwork is between the product and the nomex pad)
* Cover product with a sheet of plain white paper.
* Place a ‘Heat Conductive Thermal Mat’ on top of the paper.
* Press at 400 degrees F for 3.5-4 minutes using light to medium pressure. The ornaments are fragile and will break if care is not used.
* When pressing is finished carefully remove the transfer paper and allow to cool on a clean surface. CAREFUL handling the ornament,it will be very hot. We recommend using heat resistant gloves.
* Prepare artwork and size transfer according to the size and shape of the product.
* Image must be produced in reverse or “mirror image”
* Place a sheet of plain white paper on the press.
* If the product has a protective plastic covering remove it.
* Using heat resistant tape, secure the image with the printed side of transfer facing the product
* Lay the imprintable face up on the heat press so that you are pressing onto the transfer.
* Cover imprintable with parchment or paper
* Press at 385 degrees F for 60-70 seconds using Medium pressure
* When pressing is finished carefully remove the transfer paper and allow to cool on a clean surface
These transfer instruction guidelines were created using a Swing-Away GeoKnight Press, size 20″ x 24″/508 x 609.6 mm with pressure of 60 PSI. They represent the best, most general instructions we can provide. Please remember that heat presses may vary. Check with your press manufacturer for any special concerns. This information may change as we make continual improvements and refine our processes. These instructions are guide lines only and are based on the inks, paper, and products we supply. Your inks, papers, etc. may require adjustments in your time/temp settings.