Trailer Hitch Cover
Add a personalized touch to any truck, van or SUV. The injection-molded cover fits into the square 2”hitch receiver hole and is secured with the hitch pin. The face plate can be decorated with a team mascot, company logo, personal photo or name.
Hitch Cover Rectangle
Item UNI4573 * Hitch Cover w/Insert Unisub® 2″ Hitch Cover, Black Plastic with 4.7″ x 3.4″x .030″ White Gloss Sublimation Aluminum Insert. Injection-molded cover with clip fits into the 2″ square hitch receiver hole. Size 3.4” x 4.7”
Qty 12/case – Broken cases billed as each
$12.20 ea less than case qty
$10.29 ea per case qty
$9.53 ea 4+ case qty
Item UNI4569 * Trailer Hitch Cover – Aluminum rectangular insert spare
Size 3.4” x 4.7”
Qty 50/case – Broken cases billed as each
$3.90 ea less than case qty
$3.29 ea per case qty
$3.04 ea 4+ case qty
Item UNI5661 * Trailer Hitch Cover – FRP rectangular insert spare
Size 3.4” x 4.7”
Qty 50/case – Broken cases billed as each
$2.81 ea less than case qty
$2.53 ea per case qty
$2.42 ea 4+ case qty
* Prepare artwork and size transfer according to the size and shape of the product.
* Image must be produced in reverse or “mirror image”
* Place a sheet of plain white paper on the press.
* If the product has a protective plastic covering remove it.
* Using heat resistant tape, secure the image with the printed side of transfer facing the product
* Lay the imprintable face up on the heat press so that you are pressing onto the transfer.
* Cover imprintable with parchment or paper
* Press at 385 degrees F for 60-65 seconds using Medium pressure
* When pressing is finished carefully remove the transfer paper and allow to cool on a clean surface
* Prepare artwork and size transfer according to the size and shape of the product.
* Image must be produced in reverse or “mirror image”
* Place a sheet of plain white paper on the press.
* If the product has a protective plastic covering remove it.
* Using heat resistant tape, secure the image with the printed side of transfer facing the product
* Lay the imprintable face up on the heat press so that you are pressing onto the transfer.
* Cover imprintable with parchment or paper
* Press at 385 degrees F for 65-75 seconds using Medium pressure
* When pressing is finished carefully remove the transfer paper and allow to cool on a clean surface
These transfer instruction guidelines were created using a Swing-Away GeoKnight Press, size 20″ x 24″/508 x 609.6 mm with pressure of 60 PSI. They represent the best, most general instructions we can provide. Please remember that heat presses may vary. Check with your press manufacturer for any special concerns. This information may change as we make continual improvements and refine our processes. These instructions are guide lines only and are based on the inks, paper, and products we supply. Your inks, papers, etc. may require adjustments in your time/temp settings.