Sublimation License Plates and Frames
License Plates and Frames Show your school spirit…boost your favorite team… or just create personalized license plates.
License Plate (Aluminum Silver)
Item UNI5948 * License Plate (Aluminum Silver) : Size 11.812” x 5.875”
Qty 50/case – Broken cases billed as each.
$9.76 ea less than case
$8.23 ea per case qty
$7.62 ea per 4+ case qty
License Plate (Aluminum Gold)
Item UNI4420 * License Plate (Aluminum Gold) : Size 11.875” x 5.875”
Qty 50/case – Broken cases billed as each.
$9.76 ea less than case
$8.23 ea per case qty
$7.62 ea per 4+ case qty
License Plate Frame (Aluminum White)
Item UNI4566 * License Plate Frame, Unisub® White Gloss Sublimation Aluminum, Size 6.5″ x 12.25″ x .030″. Full size license plate frame with 4.16″ viewing area
Qty 50/case – Broken cases billed as each.
$8.95 ea less than case qty
$7.5 ea per case qty
$6.99 ea per 4+ case qty
* Prepare artwork and size transfer according to the size and shape of the product.
* Image must be produced in reverse or “mirror image”
* Place a sheet of plain white paper on the press.
* If the product has a protective plastic covering remove it.
* Using heat resistant tape, secure the image with the printed side of transfer facing the product
* Lay the imprintable face up on the heat press so that you are pressing onto the transfer.
* Cover imprintable with parchment or paper
* License Plate Frames – Press at 385 degrees F for 65-75 seconds using Medium pressure
* License Plate Aluminum Press at 385 degrees F for 75-80 seconds using Medium pressure
* License Plate Clear Gloss Press at 385 degrees F for 70-75 seconds using Medium pressure
* When pressing is finished carefully remove the transfer paper and allow to cool on a clean surface
These transfer instruction guidelines were created using a Swing-Away GeoKnight Press, size 20″ x 24″/508 x 609.6 mm with pressure of 60 PSI. They represent the best, most general instructions we can provide. Please remember that heat presses may vary. Check with your press manufacturer for any special concerns. This information may change as we make continual improvements and refine our processes. These instructions are guide lines only and are based on the inks, paper, and products we supply. Your inks, papers, etc. may require adjustments in your time/temp settings.